I have purchased a pair of A7V monitors and installed them 01 April 2026.
I have performed a calibration using SoundID Reference (I have been a user for the last four years using the plugin and ADAM Audio A7X). I wanted to upgrade to the A7V so that I could run the SoundID calibration on the monitors themselves.
When I try to upload the newly calibrated preset file to the monitors using A Control I get the following message :
Stability check failed. The sonarworks preset could not be applied, as some parameters are out of range. Try setting the lower frequency limit for the correction in SoundID to a higher freqency.
I cannot get around this error message and I have tried restarting everything, resetting everything to factory default but nothing works.
I have also searched online and cannot find anything specific to the error message. I have also asked the same question to ADAM Audio but any experience or assistance from the community here would be welcome.
0 comments