Routing input from Focusrite usb-interface through sonarworks

Updated February 02, 2023 07:19

November 20, 2020 17:41

Hi,

I can't figure out how to route my input from a Focusrite Scarlett 6i6 through sonarworks and again through my Focusrite out to headphones or speakers.

What I want to do:

I wanna tweak the sounds of my Kemper Guitar Processor, so it will fit in the mix with my DAW.

I don't want to start everytime my DAW first. It should be a quick solution. I just want to hear the signal of my Kemper through the Sonarworks correction curves right from the beginning.

Guitar-> Kemper->Focusrite->Sonarworks->Focusrite->speakers/headphones

Is there an easy workaround with a software Plugin? I've tried Soundflower and Soundsource without success. I work on a Mac.

Chris January 06, 2021 11:27

Hey Klaus,

Reference 4 can only apply calibration to your computer's output signal. Systemwide works as a virtual output device and cannot acquire the input, especially if it's routed to your outputs via direct monitoring.

A solution might be using your DAW for the monitoring signal with the plug-in enabled instead of direct output. That might however introduce some latency.

Comments