Hey everyone,
I'm using Sound ID in my homestudio and of my main concern has always been that my mixes are too bass heavy when listening back on other systems/in the car/on earbuds.
After doing the sonarworks setup the software cuts low end between 50 and 100 Hz a lot and when I engage the callibration everything sounds really thin…which would lead me to add even more bass to my mixes, which I'm pretty sure would have a negative effect.
Any ideas what I'm doing wrong here? Anyone had i similar issue?
My room is not perfect. I have absorbers on the most critical positions and bass traps in the corners. I'm under the roof though and have one slanted wall - that's the main reason for the left/right differences here
Helpful for any advice.
Thanks
Jonas
1 comment
Jonas your logic makes sense, but at the same time, the measurement must be accurate so… difficult to tell. Did you use a Sonarorworks microphone for the speaker measurements?