Can I use my own microphone calibration file?

Follow

Comments

9 comments

  • Avatar
    Mcguireryan

    On Mac OSX, you also have to make sure that the txt file is encoded in MS DOS text format and not the default MAC OS text formatting. You can change the text formatting using word, but not using the default mac text editor.

    4
    Comment actions Permalink
  • Avatar
    Dion Monti

    @Mcguireryan Thank you very much, Your tip made it work. Small but vital detail.

     

    0
    Comment actions Permalink
  • Avatar
    Andrea Caneparo

    My EMM-6 calibration file had a header, but Reference didn't refuse it, should I consider it ok or the measurement could have suffered from this?

    0
    Comment actions Permalink
  • Avatar
    Matīss

    Hey!

     

    You can try and see if the calibration curve changes with and without the header. We've found that it does not matter, but your mileage might vary. If the curve stays the same, your measurements are fine!

    0
    Comment actions Permalink
  • Avatar
    Giuseppe Vigliotti

    I use the Dayton Audio Emm-6 as measuremente mic,with its own calibration file. I have always used it with Reference 3 Measure with no issue. Now i have to modify the calibration text file to use it with Measure 4 but the software always tells me that there is a problem with my file, I tried to follow the instructions on the site with no luck

    2
    Comment actions Permalink
  • Avatar
    pierrejoseff

    hi, same problem here, the calibration profile of dayton emm6 does not work anymore with reference 4

    2
    Comment actions Permalink
  • Avatar
    Charles Kessler

    Another thing to try if you're still having issues importing on Windows..

    Use Notepad++ to change the end of line characters from CR to CR LF:

    Click Edit > EOL Conversion > Windows (CR LF)

    0
    Comment actions Permalink
  • Avatar
    Elmayordomomusic

    where can I get that .txt file to edit it with my ECM8000?

    1
    Comment actions Permalink
  • Avatar
    Pier Bover

    You should explain when is it you can input the mic profile. I thought it was on the first step with the button that say "load profile", when in fact it was a couple of steps later.

    0
    Comment actions Permalink

Please sign in to leave a comment.

Contact support

Need a little more help? Submit a request to get help from our Support Team.

Submit a request
Powered by Zendesk